Wednesday, May 12, 2010

Data Guard ORA-16789 Health Check Warning

TRADUCCION EN PROCESO

After setting up the Physical Dataguard environment some errors still showed up. Even though it looked fine and the Standby database was properly receiving and applying the archivelogs, the Dataguard Broker still showed some errors

DGMGRL> show configuration verbose;

Configuration
Name: SBDBCONFIG
Enabled: YES
Protection Mode: MaxPerformance
Databases:
PRIDB - Primary database
SBDB - Physical standby database

Fast-Start Failover: DISABLED

Current status for "SBDBCONFIG":
Warning: ORA-16608: one or more databases have warnings

Dataguard broker uses an evaluation criteria that is some sort of everything or nothing at all. Either it works fine, or it doesn't but there is no intermediate point. The issue here is that sometimes you have to be patience to find the errors. This is an 11g release, and though the solution found can work on 10g too you should be aware that after the DIAGNOSTIC_DEST parameter in 11g the path to find the log files has changed : ORACLE_BASE/diag/rdbms/ORACLE_SID/ORACLE_SID/trace/drcORACLE_SID.log, the errors displayed there were as follows:


Error Displayed

RSM Error: LogXptMode value 'ASYNC' of requires this database to have status redo logs, but they are not configured.
RSM0: HEALTH CHECK WARNING: ORA-16789: standby redo logs not configured
Operation CTL_GET_STATUS continuing with warning, status = ORA-16789


Solution

In this case it is pretty obvious why it is failing ... there are two solutions, one is to add the required Standby logfiles after the configured LogXptMode ASYNC mode, or change the LogXptMode to ARCH. I choosed the first one,

SQL> ALTER DATABASE ADD STANDBY LOGFILE GROUP 4
2 'C:\ORACLE\APP\ORADATA\SBDB\SBREDO04.RDO' SIZE 16M;
Database altered.


The command is repeated for group 5 and 6. The sizes and paths shown in this example are just for instructional purposes, on the actual production environment the size of the standby redo logs should be the same used for the production logs.


A Second Error Shows Up

The second error shown refers to the fact that since adding the standby redo log files required the recovery process to be stopped, the Data guard manager complained about it.

DGMGRL> show configuration verbose;

Configuration
Name: SBDBCONFIG
Enabled: YES
Protection Mode: MaxPerformance
Databases:
PRIDB - Primary database
SBDB - Physical standby database

Fast-Start Failover: DISABLED


Current status for "SBDBCONFIG":
Warning: ORA-16607: one or more databases have failed


This time the Dataguard logfile reports the following:
DMON: HEALTH CHECK ERROR: ORA-16766: Redo Apply is stopped
Operation CTL_GET_STATUS canceled during phase 1, error = ORA-16766


In this case it was pretty obvious too, the redo apply process was stopped to be able to add the Standby Database while the Active Data Guard was open.

Just restart the Recovery process and that's it.


Solution

SQL> ALTER DATABASE RECOVER MANAGED STANDBY DATABASE DISCONNECT FROM SESSION;
Database altered.

DGMGRL> show configuration verbose;

Configuration
Name: SBDBCONFIG
Enabled: YES
Protection Mode: MaxPerformance
Databases:
PRIDB - Primary database
SBDB - Physical standby database

Fast-Start Failover: DISABLED

Current status for "SBDBCONFIG":
SUCCESS


It works as it is supposed to.


References

Oracle® Data Guard Broker
11g Release 2 (11.2)

Part Number E10702-01

No comments:

Post a Comment